Setup Instructions
1. Red Gateway Access
To access the CPT SW application, like the other applications both in the RCC and Vessel, we need to do it via Jump Servers. You should have access to the Jump Servers via Red Gateway. In order to have access via Red Gateway, please open a Support Ticket with the IT Ops team.
| Access Point | Link |
|---|---|
| Red Gateway | link |
2. Jump Server Access
Once you are within the Red Network, you should have access to the Jump Server. Jump Servers are a middle step you need to make before accessing the machines running the Control Software.
From here, you can access any jump server, which will allow you access the target VM running the Control Software.
3. VM Access
Note
To access the VMs on RCCUK, you should use the A7801 Jump Server at the time of writing.
Once inside the Jump Server, you are able to access the VMs. Please check below how to access each VM:
| Vessel | VM Name | Access Details |
|---|---|---|
| A7803 | RCCUK-R-VM-88 | RDP using the Red Gateway credentials |
| A7803 | A7803-R-VM-11 | RDP using credentials supplied by the IT Ops team |
| ----------- | ----------- | ------------- |
| A7804 | RCCUK-R-VM-94 | RDP using the Red Gateway credentials |
| A7804 | A7804-R-VM-31 | RDP using credentials supplied by the IT Ops team |
| ----------- | ----------- | ------------- |
| A7805 | RCCUK-R-VM-91 | RDP using the Red Gateway credentials |
| A7805 | A7805-R-VM-XX | RDP using credentials supplied by the IT Ops team |
4. Run Applications
To run the applications, please refer to the HMI - Getting Started and Ifield - Getting Started sections.